Description
Veneer Application Instructions
Proper Handling and Storage
- Do not remove product from original carton until 24 hours before intended use. If the material is not in a carton, care should be taken to avoid extreme moisture conditions. In high humidity, the product should be covered in plastic.
- If the product curls, lay the sheets flat, cover with a blanket to protect the surface and apply heavy weight overnight.
- Any unused product should be covered with plastic and stored flat.
Contact Us
Fill out form below and representative will contact you soon
[hubspot type=form portal=5981224 id=edc63e77-966c-4c43-9d36-60f68e672dc0]
Contact Cement Method
STEP 1
Step 1 — Measure Application surface and cut veneer to 1/2″ oversize with release liner in place.
STEP 2
Align sheet on surface and pull back about 2 inches of release liner. Make contact with surface and make certain alignment is correct. Slowly peel back release line while applying pressure on finish side of laminate. Firm, even constant pressure must be applied to eliminate all trapped air bubbles.
Pressure Sensitive Adhesive Method
STEP 1
Measure application surface and then cut veneer to 1/2″ oversize. Follow contact cement manufacturer’s instructions exactly. Only when these instructions have been followed exactly, should you continue to step 2.
STEP 2
Align sheet on surface. Make contact with surface and make certain alignment is correct. Slowly apply pressure on finish side of laminate. firm, even, constant pressure must be applied to eliminate all trapped air bubbles.
